Unknown Leak in Lund-Rivet ?

[ Aluminum Boat and Repair Board ] [ Boat Motor Repair Board ]
Posted by James Burtke (24.91.170.187) on November 16, 2004 at 15:53:58:

I have a 2000 Lund Alaskan that I use for hunting sea ducks off coast of Mass. This summer I started taking on water from a unknown location. I first replaced the plug and made sure it was installed correctly. I examined the exterior of the hull and no obvious problem area's or rivet's. I then did the water test with boat on trailer at different positions/angles. The boat was then taken off trailer and put on stanchions to change water pressure when again tested. Water level was above deck - no obvious leak. Maybe a rivet under the cowling protecting the seem of the outer hull ? Any suggestions please, 5200 maybe? Thanks

Responses:

 The Ez-Coil Spring Rewinding Tool

See Items repaired with Durafix Rods