Re: Overheating motor


[ Ol' Paw's Boat Motor Bulletin Board ] [ Ol' Paw's Fishing Page ]

Posted by Ken Denman (24.77.36.232) on July 05, 2005 at 04:22:17:

In Reply to: Overheating motor posted by Bob on July 04, 2005 at 18:43:10:

Bob, how do you know that it is pumping water?

things to check for - 1) when the old impeller was taken out, was it intact? if not, did you account for all the peices? It is possible broken vanes are caught in a water passage somewhere. 2) Both ends of the water tube must be inserted into their respective holes with grommets - sometimes the powerhead gromment will be misplaced. 3) make sure the impeller drive pin is in place (the little steel pin inserted into the side of the driveshaft).


Durafix Aluminum Repair Rod Demo

See Items Repaired With Durafix