Re: Re: Re: 115 merc with water in lower cylinder


[ Ol' Paw's Boat Motor Bulletin Board ] [ Ol' Paw's Fishing Page ]

Posted by Ed Mc. (63.17.10.174) on July 20, 2005 at 08:47:32:

In Reply to: Re: Re: 115 merc with water in lower cylinder posted by mike steuermann on July 19, 2005 at 22:46:01:

Yes, same seals; the thickness of the sleeve is negligable as far as the seal is concerned, it'll conform to the sleeve just fine.

One caution, though, once you have the sleeve on the crankshaft, don't install the lower bearing cap then take it off again, with the new seals in it.

The lip on the crank sleeve tends to tear up any new seals if you then remove the cap.

Shouldn't be a problem in your case as I don't expect you'll be wanting to take it apart again!.....ed


Durafix Aluminum Repair Rod Demo

See Items Repaired With Durafix