4 Hp Evinrude wont run at low spped - cuts out


[ Ol' Paw's Boat Motor Bulletin Board ] [ Ol' Paw's Fishing Page ]

Posted by Alan (81.131.127.133) on September 02, 2005 at 14:29:30:

I have a 4Hp Evinrude (B91880 - E4BRCIC) that used to run perfectly but has now developed a fault. The engine fires up no problem usually 2-3 pulls. However as soon as I put the throttle to a lower position than start it cuts out. It will then start again ok and will run at high speed without any problem. The mixture is fresh and accurately measured. I have fitted new plugs and set the gap properly. I have opened the carb and cleaned it inside though couldn't see any problems. Does anyone have any suggestions as to what I should try next. Thanks in advance; Alan


Durafix Aluminum Repair Rod Demo

See Items Repaired With Durafix