Now what??


[ Ol' Paw's Boat Motor Bulletin Board ] [ Ol' Paw's Fishing Page ]

Posted by Dave (204.210.211.207) on September 03, 2004 at 14:37:08:

In Reply to: Re: 5.5HP Sears Ted Williams posted by Spike on September 03, 2004 at 04:25:30:

OK.....

I took the engine appart and I found that the two hex head screws that hold the connecting rod on (and hold the bearings in place) were too tight. I loosened them up and then tightened them back down. The motor turned by hand. I put it back together and it started and then suddenly stopped. It was again hard to pull. I pulled the carb off and again the screws on the connecting rod were really tight. Again I loonened them again...put it back together and it started and quit on me. It is now too tight to pull.

What now??


Durafix Aluminum Repair Rod Demo

See Items Repaired With Durafix